WHAT WE
CAN DO.

Our milling department runs Haas machining centers — including a UMC 750SS for simultaneous 5-axis work and a VF-4 with A/B axis — backed by a Brother RX650 for high-speed small parts and a Bridgeport with indexing head for one-offs. Maximum envelope is 50″ × 20″ × 25″.

We mill brass, aluminum, and stainless to tight tolerances, holding both dimensional accuracy and surface finish on the same part. Prototype through production runs.

A precise part with a poor finish is still a reject. We deburr, vibratory-finish, and polish in-house, so surface quality is controlled on the same floor that machined the part — not handed off and hoped for.

This matters most where the part is seen or sealed: custom hardware that has to look right, and precision components where finish affects fit and function. We finish to your callout and inspect before it leaves.

A Universal Robots UR-10e collaborative robot tends our machines for unattended and after-hours running. For repeat production, that means consistent parts and a cost structure that competes — without sending your work offshore.

The cobot handles load/unload on repeat setups. Your parts run while the lights are off, at the same tolerances and the same finish spec as the first piece.